York YS Service Manual download pdf (Page 23)

3.4 Rigging

The complete standard unit is shipped without skids.

(When optional skids are used it may be necessary to

remove the skids so riggers skates can be used under

the unit end sheets to reduce overall height.)

Each unit has four (4) lifting holes (two in each end) in

the end sheets which should be used to lift the unit.

Care should be taken at all times during rigging and

handling of the chiller to avoid damage to the unit and its

external connections. Lift only using holes shown.

Do not lift the unit with slings around

motor/compressor assembly or by means of

eye bolts in the tapped holes of the

compressor motor assembly. Do not turn a

unit on its side for rigging. Do not rig vertically.

The rigging and operating weights and overall

dimensions are given in Section 9 as a guide in

determining the clearances required for rigging. (Add

150 mm to overall height for optional skidded unit.).

035L02381-GB0 3-3

Figure 3.1Rigging

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

No comments

York YS Service Manual Page 23