York W)036 THRU 060 Specifications download pdf (Page 3)

542300-YIM-A-1009

Johnson Controls Unitary Products 3

Due to system pressure, moving parts, and electrical

components, installation and servicing of air conditioning

equipment can be hazardous. Only qualified, trained service

personnel should install, repair, or service this equipment.

Untrained personnel can perform basic maintenance functions

of cleaning coils and filters and replacing filters.

Observe all precautions in the literature, labels, and tags

accompanying the equipment whenever working on air

conditioning equipment. Be sure to follow all other applicable

safety precautions and codes including ANSI Z223.1 or CSA-

B149.1- latest edition.

Wear safety glasses and work gloves. Use quenching cloth and

have a fire extinguisher available during brazing operations.

Inspection

As soon as a unit is received, it should be inspected for possible

damage during transit. If damage is evident, the extent of the

damage should be noted on the carrier’s freight bill. A separate

request for inspection by the carrier’s agent should be made in

writing.

Reference

Additional information is available in the following reference

forms:

• Technical Guide - ZF036-060, 251933

• General Installation - ZF036-060, 542300

Renewal Parts

Contact your local York

parts distribution center for authorized

replacement parts.

Approvals

Design certified by CSA as follows:

1. For use as a cooling only unit, cooling unit with

supplemental electric heat or a forced air furnace.

2. For outdoor installation only.

3. For installation on combustible material.

4. For use with natural gas (convertible to LP with kit).

This product must be installed in strict compliance with

the enclosed installation instructions and any applicable

local, state and national codes including, but not limited

to, building, electrical, and mechanical codes.

The furnace and its individual shut-off valve must be

disconnected from the gas supply piping system during

any pressure testing at pressures in excess of 1/2 PSIG.

Pressures greater than 1/2 PSIG will cause gas valve

damage resulting in a hazardous condition. If it is

subjected to a pressure greater than 1/2 PSIG, the gas

valve must be replaced.

The furnace must be isolated from the gas supply piping

system by closing its individual manual shut-off valve

during any pressure testing of the gas supply piping

system at test pressures equal to or less than 1/2 PSIG.

This product must be installed in strict compliance with

the enclosed installation instructions and any applicable

local, state, and national codes including, but not limited

to, building, electrical, and mechanical codes.

Improper installation may create a condition where the

operation of the product could cause personal injury or

property damage.

This system uses R-410A Refrigerant which operates at

higher pressures than R-22. No other refrigerant may be

used in this system.

1 2 3 4 5 6 7 8 ... 57 58

Comments to this Manuals

No comments

York W)036 THRU 060 Specifications Page 3

Comments to this Manuals

Related products and manuals for Heat pumps York W)036 THRU 060