York FAN COIL YWC User Manual download pdf (Page 24)

Guide Specifications

Furnish and install YORK vertical floor consoles as indicated on the plans and specifications. Types, sizes, and

performance shall be as indicated in the schedule. Each unit shall be ARI certified and consist of and comply with the

following:

CASINGS AND CABINETS

Flat Top Floor Model (VFB) and Slope Top Floor Model

(VSB) – Cabinet shall be a vertical console type enclo-

sure fabricated of heavy 18 gauge galvanized steel and

finished with an electrostatically applied, baked-on light

gray paint. Cabinet shall include a discharge grille angled

to provide optimal air discharge and full width electrical

and piping compartments. The discharge grille shall be

made of heavy-duty, 18 gauge stamped steel and

painted to match unit color. Units provided with unit

mounted controls shall have a single access door. Cabi-

net shall be easily removed without tools for service.

Basic Unit (VCB) – Basic unit shall consist of base cas-

ing and removable front panel fabricated of heavy gauge

galvanized steel with top duct discharge opening for in-

stallation in custom enclosure furnished by contractor.

ELECTRICAL

Unit shall have an electrical box provided a single loca-

tion for all field wiring connections and factory installed

electrical disconnect.

COILS

Coils shall have high efficiency aluminum fins with me-

chanically expanded copper tubes. All water coils shall

have a manual air vent. Coil performance shall be as

indicated in the schedule.

FAN ASSEMBLY

Fans shall be centrifugal, forward curved, and dynami-

cally balanced for smooth, quiet operation. Fan hous-

ing shall be fabricated of heavy gauge galvanized steel

and be easily removed, thus allowing complete service

access to the fans and motors.

MOTORS

All units shall have (120/1/60) (208-240/1/60) (277/1/

60) (220/1/50) three speed motors with permanently lu-

bricated sleeve bearings, permanent split capacitor, in-

herent thermal overload protection with automatic re-

set, and resilient rubber motor mounts.

SPEED CONTROL (OPTIONAL)

Units shall have a (unit) (wall) mounted three speed

switch with integral on/off switch which shall provide high

/ medium / low fan speed control.

DRAIN PAN

Primary drain pan shall be constructed of galvanized

steel and coated to resist corrosion. Secondary drain

pan shall be constructed of injection molded plastic.

Secondary drain pan shall be capable of rotating 180

degrees to allow field piping to enter the unit from differ-

ent locations.

INSULATION

Cabinet insulation shall be 1/2” multi-density glass fi-

ber.

FILTER

Filter shall be permanent type and cleanable.

OPTIONS

Valve Packages – Valve packages shall consist of vari-

ous combinations of 2-way or 3-way motorized valves

and/or combination balance/shut-off valves on the sup-

ply and return piping.

Fresh Air Kit – A manual or motorized fresh air damper

shall be provided by the manufacturer for field installa-

tion.

Tamperproof Access Door – Units shall be provided with

tamperproof access door on the thermostat/fan control

compartment.

Tele. 800-861-1001

www.york.com

P.O. Box 1592, York, Pennsylvania USA 17405-1592 Subject to change without notice. Printed in USA

Form 115.20-EG3 (404)

Supersedes: 115.20-EG3 (1202)

1 2 ... 19 20 21 22 23 24

Comments to this Manuals

No comments

York FAN COIL YWC User Manual Page 24

Comments to this Manuals

Related products and manuals for Split-system air conditioners York FAN COIL YWC